2016

As expected, 2016 began in January, but coming to the end I realised that I hadn’t done a review blog post for several years – four years in fact, as the only 12-month review I had ever done before was for 2012.

There are several reasons for this, which I suppose might be worth mentioning briefly. By 2013, I was working full time as a teacher and so shooting time was at a minimum, and at the end of that year I had the front of my house pulled off and a new kitchen and studio area built. It took more than the next year to get things back in order again. On the other hand, the bridge between 2014 and 2015 was a period of careful watchfulness at work that resulted in a successful redundancy, after which I was effectively on early retirement.

I’d ended 2015 and begun the new year using 4×5 sheet film with the revision of a point-and-shoot camera that I’d first made in 2003. The Tutone was better designed and better equipped for both 90mm lenswork and pinhole.

Tutone
 photo IMGP6700b.jpg

11 Jan 2016, Swansea
 photo 160111_fom2_01.jpg

Although I’d replaced the Surveyor I with a II some years before, I had the frustration that at 300mm the maximum extension was on the short side for some of the lenses I wanted to try. I’d originally had three meniscus lenses cut for the Garden Camera in 2003, but never had a suitable shutter to try them out on 4×5. On the one hand I needed to find some shutters to fit the 125mm, 170mm, and 240mm lenses, but I also needed to build a camera with a longer rail in order to do close up and macro shots with these three.

The first Surveyor had been a folding field camera, the second a short-base, non-folding, triple-extension design, and the Surveyor III was built on a rail that could be extended to 500mm. I kept the same axial tilt on the front standard that I’d used on the II, combined with a new version of base tilt at the rear. I also found shutters that could hold the 30mm diameter lenses.

Surveyor III
 photo IMGP7528a.jpg

Hat Shot
 photo 160605_shang_04.jpg

For all the extra real estate of the 4×5 negative, it’s hard not to accept the logic of using 120 roll film, and at the same time I’d been looking closely at the ‘blended’ pinholes of other photographers. Different from the results of a double or multiple exposure, blending involves mating the edges of images from adjacent pinholes, which was going to be much simpler on roll film. A wholly new camera design was required; I built the Rotunda Pinhole from scraps I found in the workshop and then spent a couple of rolls chasing down and eliminating the more obvious light leaks.

Rotunda Pinhole
 photo IMGP7544a.jpg

The Trees in SA1
 photo 160601_fp4_01.jpg

Since the same could no doubt be done with 35mm, it was obviously tempting to try it out and so the Picket Pinhole was born.

Picket Pinhole
 photo IMGP7564b.jpg

Along and Across the Tawe
 photo 160623_apx_03.jpg

This last shot was picked up as an ‘inspiration’ by a new pinhole blog and publisher, f/D, based in Cleveland, Ohio.

Middle of the year the high point remains the same, the grand and internationally oriented bike ride around Cardiff – the WNBR. An ex-rider myself, I’ve been shooting this event for the past five years and always come away feeling better for it and with some solid portrait shots in the bag. Did I mention that the riders are naked? That’s what the ‘N’ stands for. This year proved as successful as ever, both in terms of publicity in raising the profile of safer road use for all, and in the more decorative aspects of the day. Order of the day, as in 2015, was to shoot with the Mamiya Meniscus.

Style
 photo 160601_proh1_01a.jpg

Content
 photo 160601_proh2_01.jpg

I picked up a number of parts at the Photographica Camera Fair in London in May which freed up other bits and pieces for some experimental camera building. I had leftover scraps of cherry and maple as well as different thicknesses of strip brass. What I wanted to deploy was the efficiency of a standard roll-film holder with a personalised focal length for the pinhole. The 38mm of the Hasselblad Superwide cameras seemed like a good target and once I had devised some clips for the rear it was quite straightforward to slip a pinhole disk into an empty lens element holder on the shutter.

I was a bit spoilt for choice on naming this one, but Blackbladder seemed vaguely appropriate.

Blackbladder 6×6
 photo IMGP7581a.jpg

Meridian Tower, Swansea
 photo 160718_fp4_11.jpg

There’s no doubt in my mind that the square beats every other format in offering a poetic challenge, but it’s the 6×7 that comes in second place. Perhaps, if you had a 6×7 film back like the Mamiya RB film holder I’d been using, you’d also have jumped straight into making up another pinhole camera. Or perhaps not, but anyway, I’d run out of orphan shutters so for this and the next camera I used a pendulum to cover the pinhole, and with the wider negative of each I slightly increased the focal length.

oRBo 6×7
 photo IMGP7594a.jpg

Big Wheel
 photo 160829_acr_08.jpg

Some years ago I’d also picked up a Graflex 23 holder, a 6×9 format. I’d found a Linhof 6×9 back for 4×5 at Photographica and so the old one could now be bolted straight into its own pinhole nose. 6×9 only gives eight shots on a 120 roll, but on the other hand you don’t have much wastage if you need the longer format.

Graflic 6×9
 photo IMGP7595a.jpg

Coming through the Canopy
 photo 160815_acr2_03.jpg

Part of the summer was taken up with the conversion of an old half-plate camera to take 4×5 sheet film. The camera and lens were from around 1910 and needed both a new face plate to carry regular modern shutters, and a new rear mount and focus screen. It had one of those old-style, finger-trapping tripod arrangements so it seemed a good idea to create a base support as well, with a 1/4” tripod thread insert.

Sanderson
 photo IMGP7647a.jpg

Bridge Work
 photo 160929_fm320_01.jpg

Another boon from my trip to Photographica had been picking up a free sample of Fomapan’s ISO320 sheet film from the guys at Parallax Cooperative. I used it for the test shot with the venerable and ancient Aldis 200/4.5 lens.

It might not sound like the most creative outlet for energy but this was the year I picked up a cheap smartphone, and the natural follow on was to start an Instagram account. I probably spent two months formally randomising a collection of the better shots from over a forty year period, tiling images that are unrelated so they can stand on their own, each framed by its difference from its neighbours: no series, no padded stories, no associations between them, just the single image, one at a time, like a well-shuffled deck.

http://www.instagram.com/sandehalynch/
 photo tilesample16.jpg

It might seem a bit of a stretch to include a few snapshots from the 1970s and say that they are equivalent to any of the portraits I’ve done more recently; and yet … the intent behind my framing and composing has barely changed over the intervening years, and the principle influences remain painters rather than photographers.

It also led to the rediscovery of shots that I’d previously ignored or projects I hadn’t completed. One of these was a panorama stitched from two Kodachrome slides – the intent had been clear when I shot them in 1983 and it was nice to be able to complete the landscape now, some thirty three years later.

Above Kagbeni, Nepal, 1983
 photo 8303_kc_214215_color.jpg

As an alternative to carrying the Mamiya Meniscus when travelling I’d used a Voigtlander single lens element on a converted Agfa Isolette. The shutter from that combination was now sitting on the Blackbladder so I had to find a position for the lens in the new focal length. The year closed off with a few rolls through the Blackbladder, both with pinhole and with a single lens element.

Flying Figurehead
 photo 161209_tmx_05_f22.jpg

Family Group
 photo 161231_400h_03.jpg

Copyright Notice. All material on this site, text and images, is the property of Sandeha Lynch and may not be used in any context without prior permission. Copyright ©2000-2016 Sandeha Lynch.
sandehalynch at yahoo dot com


%d bloggers like this: